Why choose our gear flow meters for hot melt adhesive dispensing applications

Now more and more clients choose our gear flow meters for HOT MELT ADHESIVE DISPENSING APPLICATIONS that can MEASURE TO A FRACTION OF A GRAM

Why they choose us??This is some brief introduction:

APPLICATIONS

Thermoplastic and reactive hotmelt applications’ quality and performance can change with a small amount of material.  From structural adhesives in electronics, textiles, and non-wovens to the millions of sealed packaging applications, there is an optimal amount of adhesive to get the job done

INDUSTRY PREFERRED TECHNOLOGY

Wide flow ranges, low flow accuracy, and 1.6 millisecond response times make JSN Precision Flow Meters the leading choice for measuring high viscosity adhesive and sealant dispensing.  A high degree of resolution gives the operator the ability to precisely dose the liquid onto the product or fine tune flow rates and alarm limits to perfect the closed-loop flow control.  For the widest flow ranges and the highest dosing accuracy, use:

CX-G0.1

K-Factor:  0.1ml/p

Flow Rate: 0.04-4L/min

CX-G0.2

K-Factor:  0.245ml/p

L-Flow Rate: 0.08-16L/min

HOW DO YOU BENEFIT?

20 to 40 times more pulses per gram than any other gear meter

0.01 gram per shot resolution

Integral heater cartridge and temperature probe ports for ease of use

Since adhesive application is a continuous part of the product process, final product quality is dependent on high resolution, repeatability, and accurate metering over the entire operating range. A high-performance meter will prevent over application of adhesive which can hurt product consistency and the overall bottom line and equally important, prevents under dosing which can lead to recalls, in-plant reworks, and product failures. JSN Precision Flow Meters provide the accuracy you need to maintain product consistency.

If you have any inquiry, pls reply to me by email. I will give u reply at right now.

Attached our technical data sheet for your reference.