sales01@cxflowmeter.com
Before using the magnetic flow meter, we need to understand two settings about this flowmeter. The first is the wiring method of the
flowmeter; the second is how to adjust the flow rate.
The wiring method of electromagnetic flow meter:
When the electromagnetic flowmeter uses cable wiring, in order to prevent rainwater from penetrating into the sensor, when entering the
electrical interface of the sensor, it is necessary to make a U shape at the port. If the excitation cable is used, the Yz medium-sized
rubber-sheathed cable can be used, and its length is the same as that of the signal cable; if it is installed separately, the connected signal
cable adopts a customized special cable, and the shorter the cable, the better. At the same time, it should be noted that the signal cable must
not be laid in the same pipe with other power sources, and must be strictly separated. It cannot be twisted together and should be placed in
the steel pipe separately, and cannot be laid equally. When wiring, it is recommended that the excitation cable and the signal cable be as short
as possible, and the redundant cables should not be rolled together. The redundant cables should be cut off and the joints should be re-soldered.
sales01@cxflowmeter.com
JSN Compressor oil supply lubricating oil flow meter,analysis of online oil supply
1. Working condition analysis:
Medium: diesel, (compressor inlet pipe)
Viscosity: Lubricity, similar to engine oil, thinner
Flow rate: 23ml/min (requires flow stability, flow monitoring)
Temperature: 30 degrees
Pressure: don't ask
The digital display needs to be connected to 0-10V, and the flow rate should be stable at 23ml/min required by the customer
sales01@cxflowmeter.com
JSN micro oval gear flow meters are widely used in the spraying industry, automotive painting, and motor coil painting. The spray paint industry
is a typical application for accurate monitoring of spray detection quantities.
The problem encountered by the customer at the site is that the varnish will be cut off when the flow is cut off, which will cause the rotor to not
be varnished (the varnish is transparent), and the coating amount is relatively small, so it is not easy for workers to find such a situation. This will
cause the produced rotor coil to enter the product assembly in a state without varnish coating. However, when the rotor is working, it will wear
back and forth, causing the coil to be scrapped, resulting in scrapped products and affecting the reputation of the manufacturer.
sales01@cxflowmeter.com
Turbine flow meters are widely used in the following measurement objects: petroleum, organic liquids, inorganic liquids, liquefied gas,
natural gas, coal gas and cryogenic fluids. It is widely used in foreign transshipment and gathering stations for liquefied petroleum gas,
refined oil and light crude oil
How Vortex Flow Meters Measure Steam? sales01@cxflowmeter.com
The first, and the most widely used, is the vortex flow meter with temperature and pressure compensation. This is an indirect vortex mass flow
meter. In actual use, the density is indirectly measured through the measurement of temperature and pressure, and then multiplied by the
volume measured by the vortex flowmeter to calculate the mass.
Coating company case study
Medium: paint (solvent-based paint, water-based paint)
Viscosity: 50S
Flow: 1L/MIN
Temperature: normal temperature
Pressure: normal pressure
Detection: detection of a single dispensing amount
Shanghai JSN Micro Flow Meter CO.,LTD as a high-tech industrial products manufacturing and complete sets of product sales, R & D, production, processing and sales as one, with independent import and export rights of enterprises.
The company's main flow meter, level meter, and pressure controller, temperature controller, analytical instruments and other various types of instrumentation. To solve all kinds of problems, and provide complete sales service for customers with professional technical point of view.
info@microflowmeter.com
